CORONAVIRUS FAQ’S. – We are operating as usual. Visits continue by appointment with safety measures in place.

Create your very own back garden bar with this guide from ManoMano

DIY Pallet Bar 5

Ever thought it would be cool to have a bar in your own back garden? Well those dreams can now become a reality!

The DIY gurus at ManoMano have pulled together a step-by-step guide on building a home bar which you create out of some old pallets. Here’s ManoMano’s list of everything you’ll need and how to get started!  

What you’ll need



Step one

Using a wrecking bar, remove all the planks of wood from all three pallets. Attach three of the side supports together to create an L shape and screw together. Repeat with another three side supports. These will form the upright corners at the back of the bar.

Step two

Assemble the back of the bar with the new L-shape supports on the corners. You only need to cover the bottom half of the bar (which will be visible from the inside) so position five planks closer together to remove gaps and screw them into the corner supports.

Add one plank across the top for structural integrity and add a central support. Leaving the gap on the back gives you access to add the lights later.

Step three

Attach five planks at the top of the bar on the back, positioning the planks close together. Using a piece of cardboard or paper stapled to the top of the front, mark out the BAR letters and decide where the lights will be.

Using a drill bit slightly larger than fairy light bulbs, drill the holes through the cardboard and through the wood on the front of the bar.

Step four

To create the supports for the drop-down bar, measure the distance from the base of the bar to the plank section at the top and cut down two side supports to fit this measurement. Lay out the planks close together and add the side supports, positioning them set in from the ends of the planks. This will ensure that the drop-down panel will fit inside the corner supports of the bar.

Step five

Cut away an angle from the bottom of the corner supports at the front of the bar. Place the drop-down section in position on the front of the bar and drill from the side through the corner support and the drop-down support. Add a coach bolt through the hole to act as the hinge. Repeat on the other side.

Step six

Open the drop-down section and clad the top side with the planks. Use a tank cutter to cut holes along the back of the top layer.

The holes need to be the size of your beer glasses, bottles or wine glasses, to allow them to sit inside the holes when the bar is finished. With the drop-down section closed, you’ll see a gap on the underside of the bar. Attach an extra support piece to fill the gap. This will create a ‘shelf’ behind the drop-down section when it is open.

Step seven

Sand down all the rough edges and paint the back planks and the hole section on the drop-down with copper spray paint. Use chalkboard paint (either brush-on or spray paint) to paint the top, front and sides. This will allow you to use chalk to add the words ‘birthday’, ‘cocktail’ or any phrase you like to the top of the BAR sign.

Step eight

When the paint is dry, use an eye hook and carabiner to attach a chain to the inside edge of the corner support. Add another eye hook and carabiner to the front of the drop-down section and clip on the chain.

To close the bar, add two eye hooks on each side and close with two carabiners. Working from the back of the bar, poke the fairy lights through the holes. Turn the bar over and paint a fine line of metallic paint between each fairy light to spell out the word BAR.


Get more home inspiration tips over on The Handy Mano!



Step 1 2
Step 2
Step 3
Step 4
Step 5 2
Step 6
Step 8